車輛溫度升高後無法發動

[◎阿燦◎]

請教各位前輩
車輛為05 CBR600rr
目前有個狀況
溫度過90幾度後
熄火要再發動就發不起來了
推發就可以發動
騎乘時無任內異狀
溫度降低後又可發動
電瓶已更新
想請問接下來可以往哪些方向查詢？
先謝謝大家！

[Rom]

這車壞了500 收

[chris0814]

凸輪軸位置感知器or曲軸位置感知器！最後才是汽油泵！查查看吧

[GOD00978]

整路騎八十溫度就不會上昇~
就沒這問題……

[tysonlin]

故障碼調出來看了嗎?
http://www.600rr.net/vb/showthread.php?t=85319

測試接頭接地,
FI 長亮 1.3 秒 = 十位數
FI 短亮 0.5 秒 = 個位數

舉例: 長亮1次, 短亮3次 = 錯誤碼13

CODES:

According to my manual (2003/2004):
A long blink = "10"
A short blink = "1"
DNS = Engine does not start
EON = Engine operates normally

And I quote (i.e. don't shoot the messenger):

BLINKS : PROBLEM, SYMPTOMS
No blinks: ECM malfunction, DNS
No blinks: ECM power / ground circuit malfunction, DNS
No blinks: ECM output line malfunction, DNS
No blinks: MIL circuit malfunction, EON
Stays lit: Data link circuit malfunction, EON
1 blink: MAP sensor circuit malfunction, EON
2 blinks: MAP sensor performance problem, EON
7 blinks: ECT sensor circuit malfunction, Hard start at low temp
8 blinks: TP sensor circuit malfunction, Poor performance on quick throttle operation
9 blinks: IAT sensor circuit malfunction, EON
11 blinks: Vehicle speed sensor circuit malfunction, EON
12 blinks: No. 1 Primary injector malfunction, DNS
13 blinks: No. 2 Primary injector malfunction, DNS
14 blinks: No. 3 Primary injector malfunction, DNS
15 blinks: No. 4 Primary injector malfunction, DNS
16 blinks: No. 1 Secondary injector malfunction, DNS
17 blinks: No. 2 Secondary injector malfunction, DNS
18 blinks: Cam pulse generator, no signal, DNS
19 blinks: Ignition pulse generator, no signal, DNS
21 blinks: No. 1 O2 sensor circuit malfunction (California only) , EON
22 blinks: No. 2 O2 sensor circuit malfunction (California only), EON
23 blinks: No. 1 O2 sensor heater malfunction (California only), EON
24 blinks: No. 2 O2 sensor heater malfunction (California only), EON
33 blinks: E2-PROM in ECM malfunction, EON
48 blinks: No. 3 Secondary injector malfunction, DNS
49 blinks: No. 4 Secondary injector malfunction , DNS
_________________
眼球向上鞋尖朝外手肘落下扣拉換移倒放

[◎阿燦◎]

[◎阿燦◎]

[爆Q]

[◎阿燦◎]

[sj6135]

汽門間隙太小..汽門.. 汽門座凹陷..

[CB1284-sc38e]

汽門間隙+1
既然推發可以發動~應可暫時排除電子零件
打啟動馬達引擎轉速最多300~500轉，推發轉速隨便都破千
假設汽門間隙過小~在熱車狀態有可能無法關緊造成洩漏，因為打啟動馬達轉速低+洩漏量大~所以發動困難

[◎阿燦◎]

問題已解決，原來電池型號用錯

[下營銘]

[maxcar]

啟動電流太小----電池用太小顆

[◎阿燦◎]